Before switching on the power roughing wheels, fan-like grinding wheels tool, read the operating manual! or wire brushes. When using the wall sander GE 5/GE 5 R/ Wear goggles! GSE 5/GSE 5 R, connect a Class M dust extractor. Disposal information for the old...
GE 5/GE 5 R/GSE 5/GSE 5 R Safety instructions wear, wire brush for loose or cracked wires. If power tool or accessory is WARNING! dropped, inspect for damage or install an Read all safety warnings and all undamaged accessory. After inspecting instructions.
Page 5
GE 5/GE 5 R/GSE 5/GSE 5 R Regularly clean the power tool's air Do not position your body in the area vents. where power tool will move if kickback occurs. The motor's fan will draw the dust inside...
GE 5/GE 5 R/GSE 5/GSE 5 R Noise and vibration Disposal information NOTE WARNING! Values for the A-weighted sound pressure Render redundant power tools unusable by level and for the total vibration values can be removing the power cord. found in the “Technical specifications” table.
GE 5/GE 5 R/GSE 5/GSE 5 R Overview Sanding head (GE 5/GSE 5) 12 Retaining washer with closed brush ring 13 Screw Sanding head (GE 5 R/GSE 5 R) 14 Velcro pad with open brush ring for sanding edges 15 Backing pad...
GE 5/GE 5 R/GSE 5/GSE 5 R Technical specifications Machine type Wall sander GE 5 GE 5 R GSE 5 GSE 5 R Mains voltage V/Hz 230/50 Protection class Power input Speed r.p.m. 1100–1650 Max. disc diameter Length 1520 1160...
GSE 5/GSE 5 R is a new development.If electric power tools are used with conventional connection pieces together with the extraction hose of the GE 5/GE 5 R/ GSE 5/GSE 5 R, an adapter from the FLEX accessories programme can be used.
Page 10
Using extension (optional) tool on and off An extension tube is available for the wall sander GE 5/GE 5 R/GSE 5/GSE 5 R. The extension tube can be used to increase the range when working with the wall sander. Switch on the machine: Press the switch (1.).
GE 5/GE 5 R/GSE 5/GSE 5 R CAUTION! The rotating parts of the sanding head must not come into contact with sharp projecting objects (e.g. nails, screws, junction boxes). The Velcro pad may be damaged if it comes into contact with projecting objects.
GE 5/GE 5 R/GSE 5/GSE 5 R If you stop the sander on the work surface or move the sander unevenly, this may result in a disagreeable spiral pattern of scratches and an uneven work surface. NOTE The wall sander features an overload cut- out for protecting the device.
GE 5/GE 5 R/GSE 5/GSE 5 R Replacing the protective corners Exemption from liability (GE 5 R/GSE 5 R) The manufacturer and his representative Remove protective corners are not liable for any damage and lost profit to be replaced.