Standards - Ingenico AXIUM DX4000 Hybrid User Manual

Hide thumbs Also See for AXIUM DX4000 Hybrid:
Table of Contents

Advertisement

Do not expose to strong mechanical vibrations or strong magnetic fields.
Packaging should be stored at least 15 cm above the ground and be kept away from heat,
cold, windows, or air inlet sources by at least 50cm.
Follow the specific stored conditions as noted in Section 4 of this document.

6. Standards

FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
The antennas used for this transmitter must be co-located or operating in conjunction with
any other antenna or transmitter.
The country code selection is for non-US model only and is not available to all US model. Per
FCC regulation, all Wi-Fi product marketed in US must fixed to US operation channels only.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV technician for help.
AXIUM DX4000 Hybrid
04/10
28
Banks and Acquirers International Holding SAS
Copyright©2024 Ingenico–
All rights reserved

Advertisement

Table of Contents
loading

Table of Contents