Ingenico AXIUM DX4000 Hybrid User Manual page 21

Hide thumbs Also See for AXIUM DX4000 Hybrid:

Table of Contents

4.3.2 Installing paper roll

Open the paper cover by lifting the catch located at the top of AXIUM DX4000 Hybrid and

pull the cover to the rear of the terminal.

Insert the paper roll in the compartment following the directions shown on the below

picture.

Pull the paper up to the top of terminal, maintain the paper and close the cover.

Press simultaneously on both upper corners of the paper flap until it clips into position.

Please note that the paper should be cut off upward.

ADVICE

If you insert a new R40 paper roll, tear off the first length (one complete turn to

avoid printing on adhesive footprint).

WARNING

Switch off the terminal prior to installing a paper roll. Use only paper approved

by Ingenico.

The use of no-approved paper is likely to damage the printer of your terminal.

AXIUM DX4000 Hybrid

04/10

Banks and Acquirers International Holding SAS

Table of Contents