Table of Contents
Advertisement
5 To Trigger the Oscilloscope
When working, the oscilloscope continuously acquires waveform data even if a valid
trigger does not occur. However, only when valid triggers occur, can the display
become stable. The trigger circuit guarantees that each sweep or sample starts from
the position of the trigger event in the input signal, namely each sweep and sample
are synchronous and the waveforms acquired overlap to display stable waveform.
Trigger setting should be based on the features of the input signal, thus you need to
have some knowledge of the signal under test to quickly capture the desired
waveform. This oscilloscope provides abundant advanced trigger functions which
help you to focus on the waveform details of interest.
The contents of this chapter:
Trigger Source
Trigger Mode
Trigger Coupling
Trigger Holdoff
Noise Rejection
Trigger Type
Trigger Ouput Connector
DS6000 User's Guide
RIGOL
5-1
Advertisement
Table of Contents
