Pulse Trigger - Rigol DS6062-DEMO User Manual

RIGOL

Pulse Trigger

Trigger on positive or negative pulse with specified width.
Trigger Type:
Press Type to select "Pulse". At this point, the trigger setting information as shown in
the figure below is displayed at the upper right corner of the screen.
Source Selection:
Press Source to select CH1-CH4 or EXT as the Trigger Source. The current trigger
source is displayed at the upper right corner of the screen.
Pulse Condition:
Press When to select the desired pulse condition.
: trigger when the positive pulse width of the input signal is greater than

the specified Pulse Width Setting.
: trigger when the positive pulse width of the input signal is lower than the

specified Pulse Width Setting.
: trigger when the positive pulse width of the input signal is greater than

the specified Lower Limit of Pulse Width and lower than the Upper Limit of
Pulse Width.
: trigger when the negative pulse width of the input signal is greater than

the specified Pulse Width Setting.
: trigger when the negative pulse width of the input signal is lower than

the specified Pulse Width Setting.
: trigger when the negative pulse width of the input signal is greater than

the specified Lower Limit of Pulse Width and lower than the Upper Limit of
Pulse Width.
Pulse Width Setting:
In this oscilloscope, positive pulse width is defined as the time difference between
the two crossing points of trigger level and positive pulse. As shown in the figure
below:
5-10
DS6000 User's Guide