Beam Alignment For Gls Hybrid (Dual Tubes) - GCC Technologies Spirit Maintenance Manual

Spirit/Spirit LS/Spirit GLS Maintenance Manual V.6
Step 4: Place a masking tape on the opening before Mirror 4. Move the pen carriage to the
upper left corner of the working area. Fire the laser and adjust Mirror 3 so the laser beam
passes through the center of the opening. Move the pen carriage to the upper right end of the
working table. Fire the laser and adjust Mirror 3 so the laser beam passes through the center
of the opening. The laser should pass through the same spot when the pen carriage is
positioned at upper left and upper right. Do the same for the bottom left corner and bottom
right corner.
Place a masking tape over the nozzle opening. Position the pen carriage at one of the 4
corners of the working area. Fire the laser and adjust Mirror 1 so the laser passes through the
center of the nozzle opening. Repeat for all 4 corners of the working area. After adjusting
Mirror 1, you may have to re-adjust Mirror 2 and Mirror 3 as well. (Repeating Steps 2 & 3.)
If the laser beam passes through the center of the nozzle opening at all 4 corners, then the
laser beam should have been aligned properly. Cut four 20x20 mm squares at the four
corners of the working area to double check that the edges of the square are not slanted
5.3.3 Beam Alignment for GLS Hybrid (Dual Tubes)
The beam alignment for GLS Hybrid has few more steps than other Spirit series.
First press Auto Focus key + Turn On machine together and go to hardware testing
mode.(See Chapter 7.3.4 Hardware Test for detail). Then choose Fiber laser test and tune
1064 nm mirror and let Fiber red beam pass through and hit the center of the hole on CO2
mirror panel.
107