Cleaning The Optics System - GCC Technologies Spirit Maintenance Manual

8.3 Cleaning the Optics System

8.3.1 Removing the Mirrors
We recommend that you check the mirrors once or twice a week to see if they
require cleaning.
If any debris or smoke residue is present, use the following steps to clean them.
NOTE
• Mirrors should be removed for cleaning on e a t a tim e to avoid beam
misalignment after placing them back to the lens holders.
• Refer to section 8.3.2 on how to clean the mirrors.•
The following section will illustrate the location of the four mirrors found on the
LaserPro Spirit Series for cleaning.
Mirror 1
Mirror #1 is located inside the bottom left access door panel of the LaserPro Spirit
Series.
1) Use a #2 Phillips Screwdriver to open the access panel located on the bottom
left side of the LaserPro Spirit Series.
2) Open the slot cover on the bottom left side of Spirit Series machine
3) Loosen the thumbscrew and remove the black dust cover in front of laser
tube.
Spirit/Spirit LS/Spirit GLS Maintenance Manual V.6
152