Link Fault Passthrough - Planet IXT-900-1X1UP User Manual

 Jabbers
 Collisions
 64 Bytes Frames
 65-127 Byte Frames
128-255 Byte Frames
256-511 Byte Frames
512-1023 Byte Frames
1024-1518 Byte
Frames

4.3.1.3 Link Fault Passthrough

Link Fault Pass-through
Link Fault Pass-through is a networking feature. It facilitates the detection and propagation of link faults or errors from one
network device to another. It helps maintain network reliability and minimizes downtime by allowing devices to dynamically
respond to link faults. Link Fault Pass-through improves fault detection and enables faster troubleshooting and resolution
processes.
How it works:

When a link fault occurs, the device experiencing the fault generates a notification.

This notification is then forwarded to other connected devices using Link Fault Pass-through.

Upon receiving the link fault information, the connected devices become aware of the fault.

This awareness enables them to take appropriate actions, such as rerouting traffic or disabling the affected port.
The total number of frames received that were longer than 1518 octets
(excluding framing bits, but including FCS octets), and had either an FCS or
alignment error.
The best estimate of the total number of collisions on this Ethernet segment.
The total number of frames (including bad packets) received and transmitted that
were 64 octets in length (excluding framing bits but including FCS octets).
The total number of frames (including bad packets) received and transmitted
where the number of octets falls within the specified range (excluding framing
bits but including FCS octets).
96
User's Manual of IXT-900 PoE series