Power Settings; Communication - Barco G62 User Manual

User controls – Settings menu
Low power consumption (< 2 Watt) which allows the LAN module to enter sleep mode and supports to be
woken by Wake on LAN (WoL). When the LAN module is woken by WoL, the projector is ready to receive
commands over the network.
• Communication Mode:
More power consumption that allows controlling the projector over the network.

11.4 Power settings

About power settings
Configure the projector's power settings.
Fast power on
Enable this function to have the projector turn on and off with at a fast speed.
Some parts of the projector system will be kept running in the background if the projector is turned off while the
Fast Power On function is enabled.
Signal power on
Set this function "on" to have the projector automatically turn on when input sources are connected.
This function is only available for HDMI1 and HDMI2!
Auto power off
Sets an interval timer for the projector to automatically turn off if no signal is detected within the specified time
period.
Press the ◄ and ► buttons to increase or reduce time interval.
The available time range is 0-180 minutes.
Sleep Timer
Set an interval timer for the projector to automatically turn off after operating for the specified amount of time.
The available time range is 0-16 hours.
Reset
Reset the power settings to their factory default values.

11.5 Communication

About communication
Configure the settings that allow the projector to communicate with other projectors, or control devices.
Projector ID
Assign a remote code for the projector from 00 to 99.
Use this code as the projector ID when controlling the projector by:
• RS232
72 R5914653 /10 G62