Freeze Screen; Reset - Barco G62 User Manual

User controls – Installation menu
Image 9–10
Depending on the room brightness or screen conditions, the calibration performance may vary.
If the target data is out of color range of the projector, then the color calibration will not be performed
correctly.
When encountering problems with auto image
If you encounter problem with auto image functions, verify the following:
• Make sure the built-in camera is properly connected to the projector.
• Make sure nothing is blocking the built-in camera on the front of each projector.
• Make sure there is no strong light between the camera and the projected image.
• Allow the system temperature to stabilize for more than 30 minutes after turning on the projector.
• Make sure the projection size is between 254~762 cm (100~300 inches).
• Make sure you are not using 3D mode.
Auto Image is not supported in 3D mode!
• If you still receive an error message, please contact the technician!

9.9 Freeze Screen

About freeze screen
Select to pause the display screen despite any change in the source device.

9.10 Reset

About reset
Reset all the installation settings to their factory default values.
64 R5914653 /10 G62
Enter OK
FAIL