Barco G62 User Manual page 74

User controls – Settings menu
The events support email notification include Light Source Fault, Fan Stall, Thermal Sensors, Power, and
Signal Lost/Detected. The user can send early alerts via email to one of the email address or both.
• Reset:
Resets all email notifications to their default factory values.
Control
This projector can be controlled remotely by a computer or other external devices through wireless or wired
network connection.
It allows the user to control one or more projectors from a distant control center, such as powering the
projector on or off and adjusting the image brightness or contrast.
• Crestron:
Control the projector with a Crestron controller and its related software. (Port: 41794) You can configure
the IP Address, IPID, and Port for the network connection. For more information, please visit
crestron.com.
• Extron:
Control the projector with Extron devices. For more information, please visit http://www.extron.com.
• PJLink:
Control the projector with PJLink v1.0 commands. You can configure the IP Address (Service) for the
network connection. For more information, please visit http://pjlink.jbmia.or.jp/english.
• Service:
Configure the IP Address (Service) for PJLink control.
• PJLink setup apply:
Apply the PJLink network configurations.
• AMX:
Control the projector with AMX devices. For more information, please visit http://www.amx.com.
• Telnet:
Control the projector using RS232 commands though a Telnet connection.
• HTTP:
Control the projector with a web browser.
• Cloud:
Control the projector to enable or disable the IMS(Insights Management Suite) feature.
• Reset:
Resets the control settings to their default factory values.
Crestron is a registered trademark of Crestron Electronics, Inc. of the United States.
Extron is a registered trademark of Extron Electronics, Inc. of the United States.
AMX is a registered trademark of AMX LLC of the United States.
PJLink applied for trademark and logo registration in Japan, the United States of America, and other
countries by JBMIA.
For more information about the various types of external devices which can be connected to the
LAN/ RJ45 port and remotely control the projector, as well as the supported commands for these
external devices, please contact the Support-Service directly.
Baud rate
Set the baud rate for the serial port.
Reset
Resets all the communication settings to their factory default values.
74 R5914653 /10 G62
http://www.