•
HDBaseT
•
Telnet
•
Other control methods
Remote setup
Configures the settings of the Infra-Red (IR) remote control.
•
Remote code:
Assign a remote code from 00 to 99 for the remote receivers on the projector. The projector only responds
to the IR remote control set with the same remote code.
•
Remote receiver:
Sets the remote receiver for the projector to control the communication between the projector and the IR
remote.
-
Front:
Enable or disable the front remote receiver.
-
Top:
Enable or disable the top remote receiver.
-
HDBaseT:
Select On to set the HDBaseT terminal as the remote receiver.
•
User button1 / user button2:
Assign a function to the user1 / user2 buttons on the remote control, allowing you to use the function easily
without having to go through the OSD menus.
Network setup
Configure the projector's network settings.
•
Ethernet:
Configure the projector's ethernet settings when connecting to a wired network using an "RJ-45 cable".
-
LAN interface:
Specify the LAN interface to either RJ-45 or HDBaseT.
-
MAC address:
Display the MAC address. (Read only)
-
Network status:
Display the network connection status. (Read only)
-
DHCP:
Turn on DHCP to automatically acquire the IP address, subnet mask, gateway, and DNS.
-
IP address:
Assign the projector's IP address.
-
Subnet mask:
Assign the projector's subnet mask.
-
Gateway:
Assign the projector's gateway.
-
DNS:
Assign the projector's DNS.
-
Apply:
Apply the wired network settings.
•
Reset:
Reset all network settings to their default factory values.
Email notification
The user can setup email notifications for some events, which allows them to receive early alerts via emails.
•
Email:
Display the email addresses set up on the web control panel. Up to two emails can be set to receive the
notifications. (Read Only)
•
Event:
User controls – Settings menu
R5914653 /10
G62
73