Dispenser Requirements; Front Panel Removal; Hinged Panel Models - Manitowoc Indigo NXT IDT0300A Installation, Operation And Maintenance Manual

Installation

Dispenser Requirements

Observe following recommendations unless
required by the dispenser manufacturer.
• The installation area must be capable of
supporting the combined weight of the
equipment and product.
• Dispensers requires separate electrical
outlet from the ice machine.
• An adapter is not required for ice
machines that match the dispenser size.
• Refer to Manitowoc "Suggested List Price
Standard Equipment and Accessories"
for required adapters, deflectors, and
dispenser baffles. Requirements vary by
model.
• Ice level management is recommended
to prevent water leakage or movement
of ice machine during agitation.
• Align sides and back of ice machine with
sides and back of dispenser when placing
ice machine.
• Front Panel must swing freely for service
access.
• Follow ice machine installation
procedures in this manual and any
additional installation requirements
specified by the dispenser manufacturer.
18

Front Panel Removal

HINGED PANEL MODELS

n
Follow all steps for removing and
reinstalling the front panel. Failure to
follow these steps, leaving off parts, or
overtightening screws, can lead to the
panel falling off and result in injury and
property damage. The panel is heavy.
,
It is a UL requirement to properly install
ALL panel screws. Only remove screws
from one side of the ice machine at a time.
Lifting Hazard: A single person removal
could cause injury or unit damage. Always
have assistance when handling, removing
or lifting panels. While handling, grasp
firmly to ensure the panel does not fall or
scratch the finish.
Keep fingers out of "pinch point" areas;
clearances between the panel and
between the panel and ice machine
cabinet are small.
Step 1
Use a #2 Phillips screwdriver to
loosen the two screws securing the front
panel. Do not remove they are secured to
prevent loss.
Step 2
Open front panel.
Step 3 Support with right hand, depress
top pin, tilt top of panel forward and lift
straight up off of the bottom pin to remove.
Place panels on a protected surface.
Step 4
When reinstalling, once top pin
is reengaged, hold the panel firmly against
the ice machine. Verify there are no gaps
and fully tighten the screws.
Part Number 000014141 Rev 11 12/23
Section 2
Warning
Caution