Chapter 5 Troubleshooting; No Picture - Eizo FlexScan EV2760-WT User Manual

Chapter 5 Troubleshooting

5-1. No Picture

Problem
1. No picture
• Power indicator does not light up.
• Power indicator is lighting white.
• Power indicator is lighting orange.
• Power indicator is flashing orange
and white.
2. The message below appears.
• This message appears when no
signal is input.
Example:
• The message shows that the
input signal is out of the specified
frequency range.
Example:
28
Chapter 5 Troubleshooting
Possible cause and remedy
• Check whether the power cord is connected properly.
• Turn on the main power switch on the rear side of the monitor.
• Touch .
• Turn off the main power switch on the rear side of the monitor, and
then turn it on again a few minutes later.
• Increase "Brightness", "Contrast", or "Gain" in the Setting menu (see
"Color Adjustment" (page
• Switch the input signal.
• Turn the setting "On" for "Compatibility Mode" on the "Administrator
Settings" menu (see "Compatibility Mode" (page
• Move the mouse or press any key on the keyboard.
• Check whether the PC is turned on.
• Turn off the main power switch on the rear side of the monitor, and
then turn it on again.
• This symptom may occur during DisplayPort input. Use a signal
cable recommended by us for the connection. Turn the monitor off
and on.
• Check the connection and condition of the USB devices connected
to the monitor.
This message appears when the signal is not input correctly even
though the monitor is functioning properly.
• The message shown left may appear, because some PCs do not
output the signal immediately after power-on.
• Check whether the PC is turned on.
• Check whether the signal cable is connected properly.
• Switch the input signal.
• Turn off the main power switch on the rear side of the monitor, and
then turn it on again.
• Check whether the PC is configured to meet the resolution and
vertical scan frequency requirements of the monitor (see
Supported Resolutions" (page
• Reboot the PC.
• Select an appropriate setting using the graphics board's utility. Refer
to the User's Manual of the graphics board for details.
18)).
26)).
10)).
"1-3.