Installing Jetvision Server - Paradyne CPX-1000 Installation Manual

1010-A2-GN21-00
Installing
JetVision Server
Step 1
Step 2
February 2003
■
Type a number that corresponds to the application you
are installing, then press <Enter>.
If jetutil detects that the system kernel parameters do not
meet the minimum requirement, you are given options
to save the changes to a file or enable jetutil to modify the
existing /etc/system, then reboot the machine after the
modification.
Note
After reboot, run jetutil again to make sure that the new
kernel settings are in effect.
Note
This installation procedure assumes that no Oracle is
installed on your computer.
To install JetVision Server on Solaris, follow these steps:
Log on with administrator privileges to the computer where you
want to install JetVision Server, and open a console window.
Insert the JetVision Server Solaris installation CD-ROM into the
CD-ROM drive. Use the appropriate UNIX shell command to start
the installation. For example:
cd/cdrom/cdrom0
./setup.sh
Note
Do not open any directories and files from File Manager.
Doing so may cause unpredictable behavior. If File
Manager is open, close it before running the installation
program.
3. Solaris Environment
3-5