Installation Overview; Installing Pots Cards - Paradyne 8922 Installation And User Manual

Installation Overview

In the course of installing the 8922 POTS card, you will:
❑
Obtain the applicable cable; refer to
❑
Make sure the BAC is installed and power is supplied to the chassis.
❑
Install the card in the BAC.
❑
Connect to a 66 Block or other termination point.
❑
Configure your POTS card and IADs using the web or TL1 interface. Refer to the
SCP card's online Help or the 8620 and 8820 Broadband Access Concentrators
TL1 Reference for configuration information.
Be sure to register your warranty at www.paradyne.com/warranty.

Installing POTS Cards

HANDLING PRECAUTIONS FOR
!
STATIC-SENSITIVE DEVICES
A POTS card can be installed in, removed from, and replaced in a BAC without
disrupting service to the other cards in the chassis.
Procedure
To install the POTS card:
1. Determine in which slot the unit will be installed. Verify that cards in adjacent slots
have been fastened.
2. Remove the filler plate from the installation slot and store for possible later use.
Cabling
This product is designed to protect sensitive
components from damage due to electrostatic
discharge (ESD) during normal operation. When
performing installation procedures, however, take
proper static control precautions to prevent damage.
If you are not sure of the proper static control
precautions, contact your service representative.
6
on page 9.