7 ] Connector Layout - Sharp SF-A55 Service Manual

•
Setup example
(1) If the lead edge of the original was still not to the stopper, enter
an optimum value.
(2) If the image at the lead edge of the original were to deform,
enter an optimum value to move to the glass side.
Stopper
(3) If the original were to override the stopper, enter an optimum
value to move it to the glass side.
Stopper
After finished selecting settings using test command 53; the screen
shown in the illustration bellow will appear. Select one of the numbers
from this screen then use the 10-key pad to enter a setting for items
#1 through #15.
SIMULATION No. 53
01 ∼ 04: ORIGINAL STOP POINT SETUP.
NOM THIN
1 *
*
2
3
4
05 ∼ 06: (NO PROGRAM)
07 ∼ 10: RADF SENSOR ADJUSTMENT.
07.REGIST 08.TIMING
09.EXIT REVERSAL 10.EMPTY
C
Set to between 0 and 15 as dictated by the copier's performance.
The factory setting is "8".
Original
Glass
Original
Glass
SIMP DUP
*
*
* *
* *
5 3
1~4
[7] CONNECTOR LAYOUT
1. Connections around control circuit
board
ASM interface
ASM-R drive
Control circuit board
2. Connections around feed motor
Feed motor revolution sensor
3. Connections in feed section
Document set detector
ASM tray relay (@)
ASM-A drive
– 20 –
ASM interface
ASM-R drive
ASM-A drive
ASM-A sensor
Document feed sensor
Feed motor
ASM-A relay (@)
Feed solenoid
Feed motor
ASM-A sensor