Table of Contents
Advertisement
(4) Connect the ADF tray connector.
Open the ADF cover and connect the ADF connector to the tray
connector.
Connectors
ADF cover
(5) Attach the tray.
Loosen the two mounting screws and secure the tray with the screws
as shown in the figure.
Close the ADF cover.
Mounting
screws
Plug the copier into a grounded outlet and turn the
power switch on.
Then, follow the procedure below.
(6) Set the mode.
Operate the keys on the copier to set the mode.
C
2
The above key operation will display the
1
currently set mode.
OR
2
SIMULATION No. 26-1
SORTER/STAPLE SORTER SETTING?
1. YES 2. NO
Tray
6
1
(7) Adjust the center of the copy.
Set the original on the tray and make a copy. When the copy slips out
of the center as Fig. 1 or Fig. 2, open the ADF cover, loosen the two
mounting screws and adjust the tray to correct position.
Mark
Fig. 1
Move the tray in the direction A and secure it with the two mount-
ing screws. Make sure that it is centered properly.
Fig.1
Center of copy (first copy)
Fig. 2
Move the tray in the direction B and secure it with the two mount-
ing screws. Make sure that it is centered properly.
Fig.2
Center of copy (first copy)
(8) Original lead edge position adjustment.
•
The original lead edge position for RADF can be determined using
the test command 53.
•
For it had been factory set that the lead edge should stop on the
location 8, but it may be needed to make adjustment. It can be
adjusted within a range of 8mm (8 steps) at the stopper side and
7mm (7 steps) at the glass side. Adjustment can be done for each
mode of single sided, double sided, and light weight paper.
0
1
2
3
4
5
8mm
Stopper
– 3 –
Mounting screw
A
B
Center of original
Center of original
8
9
10 11 12 13 14 15
6
7
7mm
Glass
Advertisement
Table of Contents
