YASKAWA 1000 Series Installation Manual page 53

No. Name
STOP Key
o2-02 Function
Selection
Frequency
Reference
o2-05 Setting
Method
Selection
Operation
Selection
when LCD
o2-06
Operator
Option is
Disconnected
Copy
o3-01 Function
Selection
Copy
o3-02
Allowable
YASKAWA ELECTRIC TOBP C730600 29G 1000-Series Option JVOP-180 Installation Manual
Unit
A1000/
D1000 R1000
V1000
YES YES YES
YES N/A N/A
YES YES YES
YES YES YES
YES YES YES
Description
Enables/Disables the operator panel STOP key
when the unit is operated form external
sources (not operator).
0: Disabled
1: Enabled
Selects if the ENTER key press is required
when inputting the frequency reference by the
digital operator.
0: Data/Enter key must be pressed to enter a
frequency reference.
1: Data/Enter key is not required. The
frequency reference is adjusted by the up and
down arrow keys.
Sets unit action when the option is removed in
LOCAL mode or with b1-02 = 0.
0: The drive, converter, or regenerative unit
will continue operation.
1: The drive, converter, or regenerative unit
will trigger a fault (oPr) and the motor will
coast to stop.
This parameter controls the copying of
parameters to and from the option.
0: COPY SELECT (no function)
1: All parameters are copied from the drive to
the LCD Operator Option.
2: All parameters are copied from the LCD
Operator Option to the drive, converter, or
regenerative unit.
3: Parameter settings in the drive, converter, or
regenerative unit are compared to those in the
LCD Operator Option.
Note: When using the copy function, the drive
model number (o2-04), software number (U1-
14), and control method (A1-02) must match
or an error will occur.
Enables or disables reading of unit parameter
settings.
0: Disabled - Read not allowed
1: Enabled - Read allowed
7 Related Parameters
Default: 1
Range: 0, 1
Default: 0
Range: 0, 1
Default: 0
Range: 0, 1
Default: 0
Range: 0 to 3
Default: 0
Range: 0, 1
Values
53