YASKAWA 1000 Series Installation Manual page 37

Example: Basic Operation
■
The following procedures are examples of converter operation using the option.
Note: Actual LCD display data varies based on converter parameter settings.
Procedure Example: RUN/STOP
Note: If b1-18 is not set to 0 (Operator), press
1. Apply main power to the converter. The DC Bus Voltage Reference appears after
the initial display on the option.
2. Press to show the display for inputting the DC Bus voltage reference.
If b1-18 is not set to 0 (Operator), press
3. Press
F1
reference changes to the desired voltage.
4. Press to set the output voltage.
YASKAWA ELECTRIC TOBP C730600 29G 1000-Series Option JVOP-180 Installation Manual
Procedure
LO
RE
F2
LO
to set LOCAL.
RE
to set LOCAL.
until the DC bus voltage
6 Basic Operation
LCD Display
- MODE - DRV Rdy
Volt Ref
U1-51= 0330V
U1-52= 295V
LSEQ
U1-53= 0.0A
LREF
-MONITR- DRV Rdy
Volt Ref
U1-51= 0330V
300 360
330V
← →
-MONITR- DRV Rdy
Volt Ref
U1-51= 320V
300 360
330V
← →
Entry Accepted
37