Table of Contents
Advertisement
Preparation
Tools Required
Hotwire 5020, 6020, 6024, or 7020 POTS Splitter Card
Package Checklist
4
The installation location should be well ventilated, clean, and free of
environmental extremes. Allow clearance at the front of the POTS splitter chassis
to provide access to the cables.
Read the Important Safety Instructions on page 22.
A small #1 or #2 Phillips screwdriver to tighten the POTS splitter card
fasteners.
A large #3 or #4 Phillips screwdriver to install the chassis into a rack.
A flat-blade screwdriver to install the chassis grounding wire.
Verify that your POTS splitter card package contains the following:
POTS splitter card
Plastic bag with three of each item:
— Plastic tie-wrap anchors
— #4-40 x 1/4 screws
— #4-40 x 1/4 jack screws
— 8 cable tie wraps
April 2000
5020-A2-GN10-60
Advertisement
Table of Contents
