Table of Contents
Advertisement
Installing the POTS Splitter Card into the Chassis
496-15104
12
!
HANDLING PRECAUTIONS FOR
STATIC-SENSITIVE DEVICES
This product is designed to protect sensitive components from
damage due to electrostatic discharge (ESD) during normal operation.
When performing installation procedures, however, take proper static
control precautions to prevent damage to equipment. If you are not
sure of the proper static control precautions, contact your nearest
sales or service representative.
Procedure
To install a POTS splitter card into the POTS splitter chassis:
1. Remove the slot filler panel, if necessary, by loosening the 1/4-turn fastener
on either side.
2. Slide the POTS splitter card into the chassis.
3. Tighten the 1/4-turn fastener on each side of the faceplate of the POTS
splitter card.
CO POTS Splitter
6-Slot Chassis
Filler
TM
Panel
1/4-Turn
Fastener
DSL Interface
Loop Interface
PSTN Interface
1/4-Turn
Fastener
April 2000
99-15431-01
5020-A2-GN10-60
Advertisement
Table of Contents
