Table of Contents
Advertisement
Important Safety Instructions
!
22
1. Read and follow all warning notices and instructions marked on the product
and included in this manual.
2. Use a Listed/Certified minimum No. 24 AWG wire for connection to the
interface connectors.
3. This equipment is to be connected behind the telephone line primary
protector.
4. Do not attempt to install or service this product yourself, as opening or
removing covers may expose you to dangerous high-voltage points or other
risks. Refer all installation and servicing to qualified service personnel.
5. When installed in the final configuration, the product must comply with the
applicable Safety Standards and regulatory requirements of the country in
which it is installed. If necessary, consult with the appropriate regulatory
agencies and inspection authorities to ensure compliance.
6. In addition, since the equipment is to be used with telecommunications
circuits, take the following precautions:
— Never install telephone wiring during a lightning storm.
— Never install telephone jacks in wet locations unless the jack is
specifically designed for wet locations.
— Never touch uninsulated telephone wires or terminals unless the
telephone line has been disconnected at the network interface.
— Use caution when installing or modifying telephone lines.
— Avoid using a telephone (other than a cordless type) during an electrical
storm. There may be a remote risk of electric shock from lightning.
— Do not use the telephone to report a gas leak in the vicinity of the leak.
April 2000
5020-A2-GN10-60
Advertisement
Table of Contents
