Table of Contents
Advertisement
Table B-1. AT Command and S-Register List (10 of 34)
AT
Command/
Description
S-Register
S26=
RTS-to-CTS Delay
n
Sets the amount of time the DataPort 2001 waits
after receiving the RTS signal before sending the
CTS signal to the computer. Accepts a value from
0 to 255 in 10 millisecond increments. Factory
setting is 0 milliseconds.
S41=
Dial-Line Rate
n
Sets the protocol and rate. Accepts the following
values:
0,1 = 14,400 (V.32 bis)
2 = 12,000 (V.32 bis)
3 = 9600 (V.32 bis/V.32)
4 = 7200 (V.32 bis)
5 = 4800 (V.32 bis/V.32)
6 = 2400 (V.22 bis)
7 = 1200 (V.22)
8 = 1200 (212A)
10 = 0–300 (V.21)
11 = 0–300 (103J)
12 = 1200/75 (V.23)
13 = 75/1200 (V.23)
The S41 S-Register can be set with the B or
%B command, or can be used to override the
values set by those commands.
Advertisement
Table of Contents
