Paradyne 2001 User Manual page 25

1. Turn off the computer.
2. Connect the shielded serial cable to the modem and
computer
.
Connect the serial cable's DB25 male connector to the
connector labeled COMPUTER on the rear of the DataPort
2001. (PC users must supply a serial cable. The Macintosh
version of the DataPort 2001 is shipped with a serial cable.)
Next, attach the other end of the serial cable to the
computer's serial connector.
3. Connect the telephone.
The connector labeled PHONE is used to attach a telephone
to your DataPort 2001. This allows you to have use of the
telephone for normal voice communications when the
DataPort 2001 is not in use, or for simultaneous audio and
data communication when VoiceSpan is active.
To connect the telephone to your DataPort 2001, plug the
telephone's modular cord into the connector labeled
PHONE.
To comply with FCC rules, only FCC Part 68 registered,
non-data devices may be connected to the DataPort 2001's
PHONE jack.
4. Connect the line cord.
Plug one end of the modular telephone cord into the
connector labeled LINE on the rear of the DataPort 2001.
Plug the other end of the modular telephone cord into the
telephone wall outlet.
5. Plug in the ac power transformer.
Plug the power transformer into the socket labeled POWER
located on the rear of the DataPort 2001, and then plug the
ac transformer into a grounded ac power outlet.
Use only the power transformer provided with your DataPort
2001.
6. Turn your DataPort 2001 ON.