Paradyne COMSPHERE 6700 Series User Manual page 50

NMS 6700 MIB Specifications
Table B-1. NMS 6700 MIB Objects (6 of 16)
Object
nmsTestPortNumber
(nmsTestEntry 5)
nmsTestRemoteName
(nmsTestEntry 6)
nmsTestStatus
(nmsTestEntry 7)
nmsTestLocalTotalSecondsValidity
(nmsTestEntry 8)
B-12
Description
Port number. Only applicable to a
multiport device for the following test
types:
rem-digital-loop(3)
loc-digital-loop(4)
dte-loop(5)
bert(6)
local-loop-bert(7)
rdl-bert(8)
digital-test(9)
end-to-end-test(10)
Remote device name. Applicable for
the following test types:
digital-test(9)
end-to-end-test(10)
Test status. Reason for a test failure
may be:
Invalid test parameter
Device locked by another user
Conflict with device environment
features
Configuration
Device failure
Validity of the test result object
nmsTestLocalTotalSeconds.
September 1998
Setting/Contents
aggregate(1)
port1(2)
port2(3)
port3(4)
port4(5)
port5(6)
port6(7)
Supported as read/write.
Refer to Chapter 4, Configuration , in
the User's Guide, for device name
configuration details.
idle(1) – The device is not in test
mode (from this control point); this
is the initial value after
createRequest(2).
testMode(2) – The device is in a
test mode (such as loopback); no
further test results are pending.
testRunning(3) – The device is in
test mode (such as BERT test) and
test results are pending.
testAborted(4) – Indicates that the
device test was aborted and the
device is no longer in test mode.
testFailed(5) – Indicates that the
test has failed.
Supported as read-only.
The validity objects are:
valid-final(1)
valid-intermediate(2)
not-available-yet(3)
count-overflow(4)
not-used(5)
Supported as read-only.
6700-A2-GB20-30