Advertisement
Installing an Antenna
Before installing the antenna, please make sure that the following safety cautions are
wellattended.
1. Make sure the PC and all other peripheral devices connected to it has been
powered down.
2. Disconnect all power cords and cables.
Step 1:
There are antenna holes reserved on the right side of the system and by default covered by
rubber plugs. Please remove the plug prior to installing an antenna.
Step 2:
Connect the internal cable to the board's antenna connector, screw the antenna connector
through the antenna hole with washers and nuts, and screw on the antenna as illustrated
below.
Module Connector
DFI reserves the right to change the specifications at any
time prior to the product's release. This QR may be based
on the product's revision. For more documentation and
drivers, please visit the download page at
downloadcenter, or via the QR codes to the right.
Quick Installation Guide | KS101-EHL
Chassis Wall
Cable
Antenna Connector
Antenna
Washer
Nut
www.dfi.com/
5
Advertisement
