Table of Contents
Advertisement
Chapter 2
HARDWARE INSTALLATION
X Installing an Antenna
Before installing the antenna, please make sure that the following safety cautions are
wellattended.
1. Make sure the PC and all other peripheral devices connected to it has been
powered down.
2. Disconnect all power cords and cables.
Step 1:
There are antenna holes reserved on the side of the system and covered by rubber
plugs. Please remove the plug prior to installing an antenna.
Step 2:
Connect the internal cable to the board's antenna connector, screw the antenna con-
nector through the antenna hole with washers and nuts, and screw on the antenna as
illustrated below.
Antenna
Chassis Wall
Module Connector
Cable
Antenna Connector
Washer
Nut
13
User's Manual | VP070-M8M
Advertisement
Table of Contents
