DFI CMS632 User Manual page 35

Advanced
X
Power & Performance
Aptio Setup - AMI
Advanced
Power & Performance
Intel(R) SpeedStep(tm) [Enabled]
Turbo Mode [Enabled]
C states [Enabled]
Version 2.22.1282. Copyright (C) 2022 AMI
Intel(R) SpeedStep(tm)
This field is used to enable or disable the Intel SpeedStep
the balance between system's power consumption and performance. After it is enabled in the
BIOS, EIST features can then be enabled via the operating system's power management.
Turbo Mode
Enable or disable turbo mode of the processor. This field will only be displayed when EIST is
enabled.
C states
Enable or disable CPU Power Management. It allows CPU to enter "C states" when it's idle and
nothing is executing.
User's Manual | CMS632-W480E/Q470E
Allows more than two fre-
quency ranges to be sup-
ported.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/- : Change Opt.
F1: General Help
F2: Previous Values
F9: Optimized Defaults
F10: Save & Exit
ESC: Exit
Technology, which helps optimize
®
Advanced
X
PCH-FW Configuration
Aptio Setup - AMI
Advanced
ME State [Enabled]
Manageability Features State [Enabled]
AMT BIOS Features [Enabled]
► AMT Configuration
ME Unconfig on RTC Clear [Enabled]
► Firmware Update Configuration
Version 2.22.1282. Copyright (C) 2022 AMI
ME State
When this field is set to Disabled, ME will be put into ME Temporarily Disabled Mode.
Manageability Features State
Enable or disable Intel(R) Manageability features. This option disables/enables Manageability
Features support in FW. To disable, support platform must be in an unprovisioned state first.
AMT BIOS Features
When disabled, AMT BIOS features are no longer supported and user is no longer able to ac-
cess MEBx Setup. This option does not disable manageability features in FW.
ME Unconfig on RTC Clear
When disabled, ME will not be unconfigured on RTC Clear.
Note:
The sub-menus are detailed in following sections.
Chapter 3 Chapter 3 Chapter 3
BIOS SETTINGS BIOS SETTINGS BIOS SETTINGS
When Disabled ME will be
put into ME Temporarily
Disabled Mode.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/- : Change Opt.
F1: General Help
F2: Previous Values
F9: Optimized Defaults
F10: Save & Exit
ESC: Exit
35 35 35