Table of Contents
Advertisement
Installation
Before you install your SuperLine IAD, read the Additional Notes on SuperLine IAD
Operation on page 35, and the Important Safety Instructions on page 36.
Installation consists of two main procedures:
H
Connect phone filters
H
Connect your SuperLine IAD
Connect Phone Filters to Your
Existing Phones and Other Devices
Each phone or other device elsewhere in your home or office that is connected to the
same line as the SuperLine IAD must be connected through a phone filter to minimize
background noise from the additional lines. This includes any wall phone, cordless
phone, answering machine, fax machine, modem, caller ID display device, security
alarm system, TV-based Internet access device, and direct broadcast satellite receiver
on the same line.
If you have a device you cannot unplug, such as an alarm system, call your
service provider.
Phone filters are not required if your service provider installed a jack specifically for
SuperLine service.
Use the following procedure to install phone filters on your existing phones and other
devices. Do not install a filter on the jack where the SuperLine IAD will be.
Hardware Required (Not Supplied)
You may need to obtain additional phone filters from your service provider. One filter is
supplied with your SuperLine IAD.
"
Procedure
¶
Disconnect the phone cord of your existing phone or other device from the wall
jack.
·
Plug the phone filter into the wall jack.
¸
Plug the phone cord into the PHONE jack on the phone filter.
Repeat Steps 1–3 for each phone or other device in your home or office that uses the
same line as your SuperLine IAD. Then proceed to page 7.
4
Advertisement
Table of Contents
