Pre-Installation Check; Installation Procedures - Paradyne 3100 Series Installation Instructions Manual

Acculink csu wall-mount/rack-mount adapter

Hide thumbs Also See for 3100 Series:

Preinstallation Check

Verify that the Wall-Mount/Rack-Mount Adapter package includes the following parts:

Quantity

You need a Phillips-head screwdriver to install the Wall-Mount/Rack-Mount Bracket with the enclosed screws.

The #6 x 1.0 inch screws provided are for use with wood or drywall walls. You need to provide your own special

screws for concrete or masonry walls.

To install the Wall-Mount/Rack-Mount Adapter, perform the following steps:

Attach the Velcro straps to the Wall-Mount/Rack-Mount Bracket.

Attach the Wall-Mount/Rack-Mount Bracket to a wall, equipment shelf, or equipment cabinet.

Slide the unit into the bracket and tighten the straps to secure the unit into place.

Procedures for each of these steps appear below.

The hardware included in this Wall-Mount/Rack-Mount Adapter package allows

installation in only a 19-inch RS-310-C or 23-inch DATAPHONE equipment

cabinet. It is possible to install two units side-by-side in either of the cabinets

using two Wall-Mount/Rack-Mount Adapter packages.

Equipment

Wall-Mount/Rack-Mount Bracket

17 Velcro brand Straps

L Bracket

DATAPHONE L Bracket

#6 x 1.0 Screws

#12-24 Screws

#10-32 Screws

Clip Nuts

Part Number

870-1913-0014

870-1770-0022

870-1915-0023

870-1914-0023

506-0025-0031

503-0002-0131

500-2405-1032

302-2508-0131

NOTE

3150