Connect A 2-Line Phone To Two Additional Phone Lines - Paradyne 6501 Installation Instructions Manual

Connect a 2-Line Phone to Two Additional Phone Lines

Models 6502, 6512. Use the following procedure to connect your SuperLine IAD to a
single phone with two lines. Use this configuration only if you have two additional phone
lines through your SuperLine IAD.
Cables Required (Supplied)
H
6-foot phone cable (RJ11)
Cables Required (Not Supplied)
Obtain the following from your local electronics or phone store if it is not provided with
your other equipment.
H
A 2-line phone cable (RJ14C) to connect Lines 1 and 2 of your 2-line phone to your
SuperLine IAD. (Refer to Technical Information on page 30 for more information.)
"
Procedure
Connect the SuperLine IAD:
¶
Plug one end of the supplied phone cable into the LINE jack on the SuperLine IAD
rear panel.
·
Plug the other end of the cable into the wall jack.
Connect Lines 1 and 2:
¸
Connect your 2-line phone using your 2-line RJ14C phone cable to the PHONE 1/2
jack on the SuperLine IAD rear panel. The 2-line phone cable connects both lines
through the PHONE 1/2 jack.
Connect the AC Power Transformer:
¹
Plug the power transformer into an ac outlet and the POWER jack on the
SuperLine IAD rear panel.
Complete the Installation:
l
If you have not yet attached phone filters to all your existing phones or other
devices attached to the same line as the SuperLine IAD, do so now. Refer to
Connect Phone Filters to Your Existing Phones and Other Devices on page 4.
Your SuperLine IAD installation is now complete.
18