Connect A 2-2-Line Phone To The Existing And Additional Phone 2-Line - Paradyne 6501 Installation Instructions Manual

Connect a 2-Line Phone to the Existing
and Additional Phone Line
Models 6501, 6502, 6511, 6512. Use the following procedure to connect your
SuperLine IAD to a single phone with two lines. This configuration can be used if you
have one or two additional phone lines through your SuperLine IAD.
Cables Required (Supplied)
H
6-foot phone cable (RJ11)
"
Procedure
Connect the SuperLine IAD:
¶
Plug one end of the supplied phone cable into the LINE jack on the SuperLine IAD
rear panel.
·
Plug the other end of the cable into the wall jack.
Connect Line 1:
¸
Connect Line 1 of your 2-line phone to the BASE PHONE jack on the SuperLine
IAD rear panel.
Connect Line 2:
¹
Connect Line 2 of the 2-line phone to the PHONE 1/2 jack on the rear of the
SuperLine IAD.
Connect the AC Power Transformer:
º
Plug the power transformer into an ac outlet and the POWER jack on the
SuperLine IAD rear panel.
Complete the Installation:
l
If you have not yet attached phone filters to all your existing phones or other
devices attached to the same line as the SuperLine IAD, do so now. Refer to
Connect Phone Filters to Your Existing Phones and Other Devices on page 4.
Your SuperLine IAD installation is now complete.
16