Paradyne 6501 Installation Instructions Manual page 24

Install the Ferrite Choke (Model 6510)
A ferrite choke is included with the Model 6510 only. Installation of this choke is
essential to maintain compliance with Part 15, FCC Rules.
Use the following procedure to install the ferrite choke.
Hardware Required (Supplied)
H
Ferrite choke
"
Procedure
Connect the SuperLine IAD:
¶
Pop open the ferrite choke using a fingernail or a coin.
·
Close the ferrite choke around the power cable near the cylindrical plug. Slide the
choke onto the plug as far as it will go.
¸
Plug the power transformer into an ac outlet and the POWER jack on the
SuperLine IAD rear panel.
Return to Step 6 of Connect to High-Speed Data Service on page 22.
Installing the Ferrite Choke (Model 6510)
99-16511
24
Power