Chapter 2 Hardware Installation; Hardware Installation - Paradyne 1862 User Manual

Voip iad (mgcp)

Hide thumbs Also See for 1862:

Table of Contents

1862 VoIP IAD User's Guide

Chapter 2

2.1

The figure below illustrates possible connections to the back panel of the 1862 VOIP IAD.

Caution:

Always disconnect all telephone lines from the telephone wall-outlet before servicing

or disassembling this device.

1. If you will use the USB port, install the USB driver before proceeding. See Section 2.2.

2. Connect the power adapter to the Power jack of the IAD, and then plug the power adapter

into the wall outlet.

3. Connect your analog telephone to the RJ11 FXS port for VoIP service.

4. Connect the USB port to your PC with a standard USB cable.

5. Connect the LAN port to a PC or hub with an RJ45 cable.

6. Connect the Line port to the ADSL wall outlet, a POTS splitter, or micro filter, with an RJ11

connector cable. Consult your Internet Service Provider (ISP).

7. Turn on the power switch on the rear panel.

Note 1:

If the device fails to power on, or it malfunctions, first verify that the power supply is correctly

connected, and then power it on again. If the ALARM LED flashes in red, an alarm has

occurred.

Note 2:

Restore the default parameters of the router by holding down the device's Reset button until

the FXO and FXS LED's start blinking simultaneously (about 5 seconds). After the device has

rebooted successfully, and if the connection is established, the LAN LED, ADSL LED or USB LED

will display in green, depending on the connection type.

Hardware Installation

Table of Contents