Area of interest
Warp settings
Blend
Black Level
Illumination
Display
9.3 Create new profile
1.
Adjust the necessary projector set up values for the actual user case as described in the specific topics in
this manual.
2.
Enter the menu Profiles
Settings
•
Motorized Frame parameters, if connected
-
Rotate
-
Tilt
-
Skew
•
Shutter position
•
Image orientation
•
Scaling mode
Note: Only file-based warp supported via profiles
•
Warp enabled status
•
Selected warp file
•
Transport delay
•
Mask blend
-
Enabled status
-
Start and Width for each side
•
File blend
-
Enabled status
-
Selected files
•
S-curve ("gamma")
•
Mask Black level
-
Enabled status
-
Width for each side
•
File Black level
-
Enabled status
-
Selected file
•
R/G/B gain values
•
Illumination power for each source
•
CLO enabled status
•
CLO setpoint
•
Display mode (ActiveStereo, AutoStereo or Mono)
•
3D settings
-
Dark time value
-
Swap Frame Pair On/Off
-
Sync Delay value
-
Sync Delay Invert On/Off
GUI – Profiles
R5911443 /03
UDM
115