Table of Contents
Advertisement
GUI – Installation
If a 3D emitter is used that radiates infrared beams (IR beams), the IR beams may interfere with the
IR communication between projector and the RCU. If such interference occurs, connect the RCU to
the projector using the remote cable. It is also advised to turn the IR receivers on the projector off to
avoid the 3D emitter interference. To turn off the IR receivers, see "Remote control, on/off button",
page 33.
How to adjust the projector to the 3D emitter?
1.
In the main menu, select Installation → 3D Setup.
Image 8–77 Installation menu, 3D setup
The 3D setup menu is displayed.
Image 8–78 Example of the 3D setup menu on a UDX
2.
If it is necessary to invert the stereo sync output, enable the Swap eyes option.
3.
If the projected moving 3D content doesn't look smooth enough, enable the Swap frame pair option to help
improve this.
4.
Select the desired the stereo Dark Time.
5.
Select the desired Display mode.
6.
Use the slider to set the desired stereo Sync delay.
112
R5911443 /03
UDM
Advertisement
Table of Contents
