Table of Contents
Advertisement
Create MCGD
This is a function for adjusting chromaticity by inputting optical characteristics for your projector.
Please request your dealer/distributor to perform the setting.
Shutter Mode
The lens shutter function will be activated during the switching of signals.
Please request your dealer/distributer to perform the Setting.
GPIO Control
Set this control to "Enable" when the engine is to be controlled by the External Control terminal
(GP I/O). With "Enable" set, the projector does not perform engine control.
Connection
The transmission speed (bps) is selected for your projector and a PC when they are connected by a
commercially available RS-232C straight cable.
Make a selection from among 4800/9600/19200/38400.
Title Setup
This is for the setting of input signal.
Title Select
Set an input terminal and various modes for the saved title.
• Signal Port Select ......... Select an input terminal from among 292-A, 292-B and DVI.
• Signal Config ................ Please request your dealer/distributor to make this setting.
• Data File Select ............. Select "PCF" File, "MCGD" File or "Screen" File.
Title Make
The title of input signal is saved.
Up to 14 alphanumeric characters can be entered.
Up to four titles can be saved in your projector.
Title Delete
The saved title is deleted.
Factory Default
The settings are reset to the ones at the shipment of your projector from the factory.
• All Data ............. Reset all the settings to the ones at the shipment from the factory.
• Only Title ........... Reset the title settings only to the ones at the shipment from the factory.
Test Pattern Setup
Use this function to set up the color of test pattern.
Adjustment Menus
29
Advertisement
Table of Contents
