Table of Contents
Advertisement
6. Numeric buttons (1 to 0 buttons)
Use these buttons to enter alphanumeric characters. (See page 24)
7. UNDO button
Operate this button to reset to the state of adjustment and setting at the point when a menu is
displayed.
8. CANCEL button
Press the CANCEL button to return to the previous menu item.
9. TEST button
• Press this button, and a test pattern will be displayed.
10. HELP button
• Press this button, and input the menu item number by numeric buttons, it can be jumped to the
menu item (Direct menu selection function). If you want to the menu item number, see page
25-26.
• Press the HELP button while depressing the CTL button, to store lens position shift in your
projector (lens memory function).
11. POSITION button
Press the POSITION (LENS) button while depressing the CTL button, to make lens shift adjustment.
(See page 20)
12. PICTURE MUTE button
• Press this button to turn off image projection temporarily. Press it again, and the image will
be projected again.
• Press the PICTURE MUTE (SHUTTER) button while depressing the CTL button, then the
lens shutter will operate to shut off the light for projection. Press this button again while
depressing the CTL button to cancel the operation of the lens shutter.
NOTE
•
When the GPIO control is in "Enable," the PICTURE MUTE function will not work.
13. KEYSTONE button
Press the KEYSTONE (R) button while depressing the CTL button, then the red (R signal) of the
test pattern will be turned off temporarily. Press this button again while depressing the CTL button,
and the red (R signal) will be projected again.
12
Checking the Supplied Items and the Names of the Projector Parts
Advertisement
Table of Contents
