Connecting The Various Control Terminals - Digital Projection International iS10 User Manual

Information for Reducing Radiation of Electromagnetic Waves
To reduce unnecessary radiation of electromagnetic waves, use the supplied ferrite clamp core,
Installation Instructions
1. Open and attach the ferrite clamp core to the supplied HDSDI signal
cable as close as possible to the end that goes to the projector.
* Push the catch to open the ferrite clamp core.
2. Close the ferrite clamp core tightly.
3. Fix the supplied band to the signal cable as a stopper.
* Pull the end of the band to tighten it. Cut off the surplus of the
band.

2-3. Connecting the various control terminals

For control, your projector comes with such ports as the USB ports (type A/type B), the PC control
terminal and the Ethernet port (RJ-45).
•
USB port (Type A) (USB A) ........................ For future extension.
•
USB port (Type B) (USB B) ........................ Use this port when controlling the projector in USB
•
PC control terminal (PC CONTROL) .......... Use this terminal when controlling the projector in
•
Ethernet port (LAN1) ................................... Use this port when controlling the projector in LAN
LAN cable
connection from a PC.
serial connection from a PC.
connection from a PC.
RS-232C
USB cable
NOTE: Be sure to use the ferrite clamp core
at the end of the HDSDI signal cable.
Installation and Connection 15