Hitachi HF-W7500 65 Instruction Manual page 282

< NOTE >
・ If you mount the replacement drive before "Not mounted" is shown, it might not
be recognized. Make sure that you wait until "Not mounted" is displayed.
6. Mount the replacement drive on the computer.
(See "6.3.6 Installing and removing an HDD or SSD".)
The HDD/SSD status lamp blinks after a while and RAID1 rebuilding starts.
The RAID1 rebuild takes about 3 hours 30 minutes for HDD and 1 hour and 30 minutes
for SSD (when there is no load on the drive).
<NOTE>
・After about a minute, if the HDD/SSD status lamp is on but the rebuild does not
start, remove the drive and perform the procedure again, starting from step 5.
・After the drive has been mounted on the equipment, the hardware status display
window displays the drive bay status, as shown in the following figures until
rebuilding is completed.
Note that "Offline" might not be displayed immediately after the drive is mounted.
Immediately after the drive is mounted During the rebuild
10-10
10. RAID1