Table of Contents
Advertisement
SAFETY INSTRUCTIONS (Continued)
⚫ Put the HDD or SSD on a shock-absorbing material such as an antistatic
cushion even for a temporary task. If you put an HDD or SSD directly on a
hard surface such as a desktop, a failure or a shorter life span of the unit or
loss of data may result due to possible jarring or shock.
⚫ Never remove the screws on an HDD or SSD while the power to the unit is
on. Never hot-swap HDDs or SSDs. If you do either of these, failure of the
equipment or the drive may result.
⚫ Before you replace an HDD or SSD, make sure you shut down the OS,
unplug the power cord from the outlet, and wait for at least one minute.
⚫ When you need to replace a failed HDD or SSD in RAID1 while the power
is on, see "10.4.2 Recovery from a failure in one drive".
⚫ Install or remove an HDD or SSD only if necessary, for example, when you
need to replace an HDD or SSD due to failure. If you do it frequently, failure of
the equipment may result.
⚫ Fully insert an HDD or SSD. Loose contact and missing screws may result in
failure.
⚫ Do not give a shock to an installing HDD or SSD and the already mounted
HDD or SSD during installing. If you give a shock to an HDD or SSD,
failure of the drive may result.
⚫ When installing/removing an HDD/SSD in drive bay 3, be careful and
insert/remove it straight. If the connector is not inserted and removed
straight, it may not mate properly.
⚫ Make sure you do not apply too much force to the connector of the DVD
drive and the top of the DVD drive. If you do so, failure of the DVD drive
may result.
⚫ The orientation of a rack-mounting metal fitting is fixed if it is to be attached
to the equipment. Make sure the orientation is correct.
S-15
(Page 6-15)
(Page 6-18)
(Page 6-20)
Advertisement
Table of Contents
