Mitel 6905 SIP User Manual page 41

Call transfer with prior notice (you are in a call):
Put the handset on-hook.
The other party is then called directly by your first call partner.
Recall: If the other party does not answer, the call comes back to your phone.
Note: You can change the procedure by first starting an enquiry call before call trans-
fer.
Take (pick up own call)
You want to transfer a call from one phone to another without interrupting
the connection (for example, from a desk phone to a cordless phone).
The take function can be used to transfer calls between your phones.
Requirements: You are using the one number user concept (see the chap-
ter "One number user concept", page 7).
You must save this function to a configurable key using Self Service Portal
(see the chapter "Configuring or deleting a key assignment", page 85).
Picking up your own call (you are in an active call):
Press the function key for Take.
After a brief moment, you are connected with the caller on another phone.
Starting announcement
You want to speak directly to an internal user or an announcement group
via the loudspeaker - where available - without expecting an answer (simi-
lar to an intercom). The recipient is alerted to the announcement by two
short signal tones. You are immediately unilaterally connected via the
loudspeaker.
If the internal user has secured their phone against announcements (con-
figuration see the chapter "Activating protection against call types",
page 79), you cannot contact them using an announcement. You will get
the engaged tone.
The announcement function must be saved to a configurable function key
with Self Service Portal (see "Configuring or deleting a key assignment",
page 85). You can either configure the function key directly with a desig-
nated user or input the call number manually each time.
Starting the emergency announcement:
Mitel 6905 SIP / Mitel 6910 SIP
Version 1.0/ – R7.0 – 12.2021
Phoning
41