Table of Contents
Advertisement
FITTING REQUIREMENTS
This cooktop can be built into a working
surface
30 to 50
mm thick and 600 mm deep.
In order to install the ceramic hob into the
kitchen fixture, a hole with the dimensions
shown in figures 1.1a and 1.1b has to be
made, keeping in consideration the following:
•
The cooktop shall not be installed directly
above a dishwasher, fridge, freezer,
washing machine or clothes dryer, as
the humidity may damage the cooktop
electronics.
•
If the cooktop is installed above an oven,
the oven shall be provided with cooling
fan. The two appliances should be
connected to the electrical supply with
independent connections.
•
IMPORTANT WARNING! This cooktop
requires adequate supply of fresh,
cool air to fully function. The base
of the cooktop must have direct
unrestricted ventilation to the room
where the cooktop is installed. Follow
the requirements of figure 1.3a or
1.3b.
•
The ceramic hob must be kept no less
than 60 mm away from any side wall (from side edge of cutout).
•
The rear wall must be at least 50 mm from the ceramic hob (from rear edge of cutout)
•
There must be a distance of at least 650 mm between the hob and any wall cupboard
or extractor hood positioned immediately above (see fig. 1.2).
•
The walls surrounding the cooktop must be made of heat-resistant material.
•
Do not install the appliance near inflammable materials (eg. curtains).
Oven with
cooling fan
min 30 mm
Minimum clearances and
ventilation requirements
(oven installed below)
10
10
60 mm minimum
between the side of the
cut-out and the side wall
Fig. 1.3a
min 5 mm
min 30 mm
Minimum clearances and
ventilation requirements
(cupboard below)
IMPORTANT: a drawer is not
admitted below the cooktop
Fig. 1.2
Fig. 1.2
Fig. 1.3b
min 5 mm
Advertisement
Table of Contents
