Table of Contents
Advertisement
Available languages
Available languages
Pull out the power plug before
every maintenance operation. There
is a risk of electrocution or of injury
from moving parts.
General cleaning
instructions
• In case of transport for utilization in
different locations, the pump must be
cleaned with clear water after every
use.
• In case of stationary installation, the
function of the fl oat switch (5) is to be
checked regularly (at the latest every
three months).
• With a water jet, remove fl uff and
fi brous particles which are possibly pre-
sent in the pump casing (3).
• Clean precipitation from the fl oat
switch (5) with clear water.
• Regularly remove sludge from the pit
base (at the latest every 3 months) and
also clean the shaft walls.
• Dirt on the bottom of the pump can be
washed down with clear water.
Any measures above and beyond these,
particularly opening the equipment, are
to be carried out by an electrician. In the
case of repairs, always contact our service
centre.
To replace the
backfl ow stop
Regularly examine the backfl ow stop (10).
The backfl ow stop is defective if the rubber
cap is torn off.
Replace a defective backfl ow stop (see
"Replacement parts/Accessories").
1. Unscrew the hose adapter (9) on the
angle adapter (11) and take out the
backfl ow preventer (10).
2. Set the backfl ow stop (10) between the
angle adaptor (11) and the hose adap-
tor (9) in such a manner that the stop
is opened in the fl owing direction and
closed against the fl owing direction.
Storage
• Clean the pump before storage.
• Store the appliance in a dry, frost-free
place, and where children cannot gain
access to it.
• When the pump is not to be used for
a longer period, it must be thoroughly
cleaned after its last use, and before it
is next used. Otherwise there may be
problems in starting the pump, caused
by deposits and residues.
• Wrap the power cable (2) around the
cable holder (13) and the pump outlet
(4). See illustration
Waste Disposal and En-
vironmental Protection
Be environmentally friendly. Return the
tool, accessories and packaging to a recy-
cling centre when you have fi nished with
them.
Electric appliances should not be
disposed of in the domestic gar-
bage.
Directive 2012/19/EU on waste electrical
and electronic equipment: Consumers are
legally obliged to recycle electrical and
electronic equipment in an environmen-
tally sound manner at the end of its life.
In this way, environmentally friendly and
GB
MT
.
27
Advertisement
Chapters
Table of Contents
