Maintenance/ Cleaning/Storage; General Cleaning Instructions; Cleaning The Fi Lter; Flushing The Pump - Parkside PRPA 20-Li A1 Translation Of The Original Instructions

IE NI
Overview of the LED indicators on
the charger (23):
Green LED lights up without battery in-
serted: Charger is ready.
Green LED lights up: Battery is charged.
Red LED lights up: Battery charging.
Red LED fl ashes:Battery overheated
Red + green LEDs fl ash: Battery defective
Note the label on the device itself for
the LED display on the smart charger.
Maintenance/
Cleaning/ Storage
Clean and maintain your equipment regu-
larly. This will guarantee its performance
and long durability.
Ask our service centre to car-
ry out any work that is not
described in these instruc-
tions. Use only original parts.
There is a risk of injury!
Remove the battery from the con-
trol panel before carrying out any
maintenance or cleaning work on
the device.
There is a risk of electric shock or
injury from moving parts.

General cleaning instructions

• Clean the pump with clean water after
each use.
• Remove any fl uff and fi brous particles
that may have become trapped on and
under the pump housing with a water
jet.
12
Cleaning the fi lter
(Fig. D)
The pump has a fi lter at the suction foot
(13) which protects the pump from dirt con-
tamination. Depending on how dirty the
water is, it should be checked occasionally
and cleaned if necessary:
1. If necessary, remove the battery (21)
from the control unit (8).
2. Remove the suction foot (13).
3. Clean the suction foot (13) under run-
ning water.
4. Mount the suction foot (13) in reverse
order.
The pump must not be operated
without the suction foot (13).

Flushing the pump

After pumping heavily polluted water, the
pump must be fl ushed to prevent deposits
in the pump.
• Pump lukewarm water (max. 35 °C)
until the pumped water is clear.

Storage

• Clean the pump before storage.
• Store the appliance in a dry, frost-free
place, and where children cannot gain
access to it.
• When the pump is not to be used for
a longer period, it must be thoroughly
cleaned after its last use, and before it
is next used. Otherwise there may be
problems in starting the pump, caused
by deposits and residues.
All other measures, particularly
opening the pump must be carried