Table of Contents
Advertisement
Teldat S.A.
• Power: 9W.
• Dying Gasp Alarm to notify users in the event of a power failure or when the power supply cable is disconnected.
Please note that an additional accessory is required to enable this functionality.
• LAN: RJ45 connector will support IEEE802.3 Ethernet over copper wiring standards of 10Base-T, 100Base-TX,
and 1000Base-T
• WAN: Gigabit Ethernet Combo RJ45+SFP connector:
• RJ45 connector will support IEEE802.3 Ethernet over copper wiring standards of 10Base-T, 100Base-TX, and
1000Base-T.
• SFP port will support 1000Base-X Fiber Ethernet standard SFP.
• Serial Ports.
• 1xRJ45 connector RS-232 port (DCE).
• 2xRJ45 connectors for RS-232 port (DCE) and/or RS-485 (2/4 wires). Its availability requires one additional ac-
cessory.
• WWAN: Depending on the model. ("L" models)
• 1xLTE Category 4 WWAN module with two SMA connectors.
• 2 Internal SIM trays with 2FF form factor.
• External Reset/Recovery push button
2.4 Components
2.4.1 Front panel
The front panel contains a variety of status LEDs.
Take a look at the following figure to get a better visual understanding of the front panel layout.
Front Panel
Fig. 4:
During startup mode, LED L will light up in green. Once the device has successfully booted up, the LEDs will indicate
the following:
LEDs
LED
Associated Inter-
face
Power
ON
Regesta Smart PLC
Status
Description
Off
Device is not powered on.
Green
Device is powered on.
2 Product Overview
7
Advertisement
Table of Contents
