Table of Contents
Advertisement
ERROR RECOVERY PROCEDURE
UNITMFCU
Condition
p
STATUS 1/0
H
Requiring
R B
B Att
A
1/0
I
y
I
Lite
L
OPERATOR
Attention
0
T
T
T
RECOVERY
PROGRAM
R E
ID
DESCRIPTION
PROCEDURE
ACTION
Punch
2
1
1
Off
F4
Punch check means that extra
1.
Observe the back-lit panel
The restart procedure is re-
Check
or missing punches are in the
on the MFCU to determine
issue the last command except
card in the stacker indicated by
which hopper fed the last
that if read was specified, the
the second halt.
card.
read portion of the command
2.
Check to determine if blank
will not be re-executed. This
Second Halt
cards or prepunched cards
way, a blank card is fed in from
01
Stacker 1
are being punched. If blank
the correct hopper, the informa-
02
Stacker 2
•
cards are used, remove the
tion is punched, printing is
03
Stacker 3
last card in the indicated
done if specified, and the card
04
Stacker 4
stacker and do Action 7.
is stacked in the proper stacker.
If prepunched cards are
Since processing may have
used, proceed with Actions
taken place in the read buffer,
3-8.
(If in doubt, assume
the read portion is not re-
prepunched cards are being
executed.
used.)
3. Press CPU start key* to
ob·
tain stacker for error card.
4.
Mark the last card in the in-
dicated stacker.
5.
Press stop on the MFCU.
6.
NPRO the feed from which
the last card was fed. Place
in that hopper a blank card,
followed by the card run
out, followed by the re-
maining cards in that hop-
per.
7. Press start on the MF CU.
8.
Press CPU start key.*
9.
Upon completion of the job
or removal of the cards from
the stacker, do the following:
a. Manually punch the in-
formation from the
marked card into the
card immediately follow-
ing it, checking for extra
punches which may have
resulted from the punch
check.
b. Discard the marked card
and replace the remain-
ing card at its proper
place in the deck.
c. Mark the card and make
a note to the program-
mer to check the card.
*If the dual program feature is installed, press the halt reset key.
Figure 2-11. (Part 3 of 6) Error Recovery Procedures (MFCU)
2-16 (1/71)
Advertisement
Table of Contents
