Table of Contents
Advertisement
11 Commissioning
11 Commissioning
Corrosive chemicals!
▶ Risk of caustic burns.
Wear suitable protective gear.
●
Completely drain the plant.
●
Leakage
▶ Emission of dangerous materials.
Provide precautionary measures against exceeding the
●
maximum permitted pressures caused by pressure
surges (water hammer).
Cleaning agent
▶ Damage to the GEMÜ product.
The plant operator is responsible for selecting the clean-
●
ing material and performing the procedure.
1. Check the tightness and the function of the product (close
and reopen the product). Due to the setting behavior of
elastomers, the bolts may need to be retightened follow-
ing the installation and commissioning of the valve.
2. Flush the piping system of new plant and following repair
work (the product must be fully open).
ð Harmful foreign matter has been removed.
ð The product is ready for use.
3. Commission the product.
4. Use suitable connectors.
5. Connect the control medium lines tension-free and
without any bends or knots.
12 Operation
The product is pneumatically operated.
● Observe the enclosed actuator instructions.
GEMÜ P600S
WARNING
CAUTION
CAUTION
22 / 31
www.gemu-group.com
Advertisement
Table of Contents
