Remove An Ipv4 Acl - NETGEAR S3600 Series User Manual

S3600 Series 8- or 16-Port 10G/Multi-Gigabit Ethernet Smart Switch with 2 SFP+ Ports
The IP ACL/Rules page displays.
The IP ACL Configuration section displays the total number of IPv4 ACLs, IPv6 ACLs,
and MAC ACLs that are configured on the switch and the maximum number of ACLs
that can be configured.
6. In the IP ACL/Rule Table section, select the check box for the IP ACL.
7. Click the Edit button.
The Edit IP ACL/Rule pop-up window displays.
8. In the Name field, type a new number or name.
• Number from 1–99: Applies to a standard IP ACL.
• Number from 100–199: Applies to an extended IP ACL.
• IP ACL name: Applies to an extended IP ACL with a name string that is up to
31 alphanumeric characters in length. The name must start with a letter.
9. Click the Save button.
Your settings are saved.

Remove an IPv4 ACL

You can remove a standard or extended IPv4 ACL that you no longer need.
This procedure applies to standard and extended IPv4 ACLs.
To remove an IPv4 ACL:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network,
or connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser and enter the IP address of the switch in the address field of
your web browser.
If you do not know the IP address of the switch, see Access the switch on-network
and connected to the Internet on page 25 or Access the switch off-network and not
connected to the Internet on page 32.
The Device Admin Password page displays.
If you did not yet activate your warranty, the Register to activate your warranty page
displays. For more information, see Register the switch on page 35.
3. Enter one of the following passwords:
• Enter your device admin password.
• If you previously managed the switch through the Insight Cloud Portal or Insight
app, enter the Insight network password for the last Insight network location.
Configure Access Control Lists 464 User Manual